Cut-off wheel

Metaaltechniek has the largest range of Cut-off wheels available from stock

 

In the field of cut-off wheels, we carry several brands. For all materials there is a cutting disc for all materials. It is important that you choose the right correct cut-off wheel for your application, so that the wheel can perform optimally.

Progress line of cut-off wheels from Lukas

A topper in the field of cut-off wheels is the Progress line from Lukas. PROGRESS - stands for a perfectly matched matrix of a high-performance abrasive grain and an innovative synthetic resin bond. With increased holding forces, so that each grit is held held in the grinding wheel even longer and is used optimally. For you, this means maximum efficiency thanks to significantly more cuts per cutting disc. The PROGRESS low wear results in significantly reduced odor and dust generation and thus improves ergonomics in the daily use. Fewer tool changes with simultaneously high cutting speed provide time advantage. See for yourself with every cut how ergonomic PROGRESS cuts a wide variety of steel and stainless steel types with only minimal effort. stainless steel. This allows you to work for longer periods without fatigue-free work.

3M Cubitron II cut-off wheels

The 3M Cubitron II cut-off wheels are a revolution in the grinding world.

Some features of the 3M Cubitron II cut-off wheels

Cut faster and last longer than conventional discs. Thanks to 3M technology, which completely changes the grinding process, Cubitron II abrasives guarantee the following: Faster grinding, Material stays sharp longer, Less pressure exertion required, Less user fatigue, Higher productivity.

The secret of Cubitron II minerals in the cut-off wheels

 

The secret behind the strength and performance of Cubitron II products lies in the revolutionary 3M Precision Shaped Grain technology developed by 3M.As the triangular-shaped minerals wear down, very small fragments break off such that new sharp minerals appear again and again on the surface. The minerals wear evenly; a consistent finish, enormous cutting power and long tool life are the result.

Optimal speed for the cut-off wheels

If the speed of the machine machine being used is too low, cut-off wheels tend to "jumping," which will cause the edge of the disc to wear unevenly and excessively fast wear. The maximum permissible values for RPM and peripheral speed are indicated on the label. In the interest of your own safety, you should therefore not exceed these values when grinding.

Safety tip
For the safety of the user, we recommend replacing 0.8 mm cut-off wheels with 1 mm or 1.6 mm cut-off wheels where the work allows. The thin wheel is more fragile and breaks more quickly than a slightly thicker disc, with all the possible consequences.... Obviously, it is necessary to use personal protective equipment anyway when you are grinding.

Diameters
The Luke Progress cut-off wheels are available in diameters ranging from 100 to 230 mm and in thicknesses of 1.0 or 1.6 mm or 3 mm (Ø 230 only) thickness.
The CubitronII cut-off wheels are available in diameters ranging from 76 mm to 230 and in thicknesses from 1 to 3 mm.
Furthermore, we have a broad line Klingspor & Rhodius cut-off wheels in stock, so we can always offer you the best disc offer.